Pull trigger and remove (push out) hammer pivot while holding trigger in rearward position (See Figure B).Ħ. CAUTION: Do not remove the disassembly pin until the mainspring assembly is reinstalled in the revolver at the time of reassembly.ĥ. With thumb on hammer spur, squeeze trigger allowing hammer to go fully forward. (The disassembly pin is carried in the hole in the grip panel locator.) Lacking a disassembly pin, any similar implement will serve (See Figure A).Ĥ. Insert disassembly pin about one half its length into the hole at the lower end of the mainspring strut. Using a properly fitting screwdriver, remove grip screw and lift grip panels from frame.ģ. Be certain the revolver is unloaded and the cylinder is closed before starting disassembly.Ģ. Read instructions before disassembling gun.ġ. A loaded cylinder can discharge if dropped or struck. Never install or remove a loaded cylinder. Never clean, lubricate, disassemble or work on a revolver while it is loaded.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |